Drag Fishing Reel
| Powered by phpBay Pro |
Why does the new line on my fishing pole keep unraveling?
I have a spinning reel pole and just put pretty good quality (new) line on it, however, upon casting and locking/unlocking the line, the line with spring off the top of the drag adjust knob like crazy. What is the reason? Is it put on poorly? The new line was on a much bigger cylinder when purchased and the spinning reel that is on my pole is smaller, so maybe its just adjusted to fit properly??? HELP!
hey there, the main reason that a spinner will unspool its line like that is because there is too much line on your spool. even though a spool says that it holds 100 yrds, 200 yrds, 500yrds, of line there is no reason to put that much on it. for me my rule of thumb is i change out my line once a year. in a years time how much line are you actually going to use. usually with out breaking off massive amounts of line or popping line i probably dont use up no more than 50 yards of line. and also think how far you cast your line. i dont usually toss out no more than 30 yrds. usually pitch my lure 20-30 feet away. so i dont need alot of line. even if your spool will succesfully hold 200 yrds of line do you cast that far and use that much. if your spool is full and a year goes by and you change out our line, look at all that line that will be tossed out. I usually buy a 300-500 yard spool of line and i usually will finish that spool in about 4 years. waste not want not. i only spool my spinners about half way and that is more than a plenty. I know it looks pretty to have a whole spool of new line but it is not needed. i know that i rambled on a lot so i hope this helps you out a bit good luck good fishin be safe and remember to share the experience
| Powered by phpBay Pro |
